Calculadora de Pendiente de Techo

Cómo Usar Esta Calculadora

1. 1Measure the vertical rise of your roof in inches — this is how many inches the roof goes up over a horizontal distance.
2. 2Enter the horizontal run in inches (standard is 12 inches for conventional pitch notation like 6/12).
3. 3Click Calculate to get the pitch ratio, angle in degrees, slope percentage, and area multiplier.
4. 4Use the area multiplier to convert your flat (plan-view) roof area to actual roof surface area — multiply flat area by this number.

Sobre Este Material

Roof pitch is the ratio of vertical rise to horizontal run, typically expressed as inches of rise per 12 inches of run (e.g., 6/12). It is one of the most critical dimensions in roofing because it determines material suitability, water shedding performance, structural load paths, and walkability for installers. Common residential pitches range from 4/12 to 8/12. A 4/12 pitch (18.4°) is the minimum recommended for standard asphalt shingles and is easy to walk on. A 6/12 pitch (26.6°) is the most popular in the United States, offering a balanced look and good water shedding. An 8/12 pitch (33.7°) and steeper provides excellent snow shedding and a dramatic roofline but increases material costs and labor difficulty. In northern climates with heavy snowfall — such as Minnesota, Michigan, and the Northeast — steeper pitches of 8/12 to 12/12 are common to prevent dangerous snow accumulation. In the South and Southwest, lower pitches of 4/12 to 6/12 prevail because snow load is not a concern. Low-slope roofs (below 2/12) require special roofing systems such as modified bitumen, TPO, or EPDM membrane because shingles cannot reliably shed water at such shallow angles. Pitch also affects material quantity: a 12/12 pitch roof has 41% more surface area than the same footprint at flat, requiring proportionally more shingles, underlayment, and sheathing. The roof area multiplier converts plan-view area to actual surface area, saving contractors from costly underestimates.

Consejos de Instalación

• •Use a pitch gauge or speed square placed on a rafter or truss tail to verify pitch before ordering materials.
• •For inaccessible roofs, measure pitch from inside the attic by holding a level horizontally and measuring rise at 12 inches of run.
• •When using a smartphone inclinometer app, place the phone directly on the roof surface or a rafter for the most accurate angle reading.
• •Always verify pitch on multiple sections of the roof — dormers, additions, and garage roofs often have different pitches than the main roof.
• •Convert pitch to the area multiplier before estimating materials — a steeper roof uses significantly more shingles, underlayment, and sheathing than the flat footprint suggests.

Errores Comunes a Evitar

• ⚠Confusing rise and run — rise is vertical (up), run is horizontal (across). Swapping them gives the wrong pitch.
• ⚠Measuring along the slope instead of horizontally for the run — run must be the horizontal distance, not the rafter length.
• ⚠Assuming the entire roof has one pitch — many homes have multiple pitches across different sections.
• ⚠Using flat (plan-view) roof area for material estimates without applying the pitch multiplier — this leads to material shortages on steep roofs.
• ⚠Ignoring minimum pitch requirements for the chosen roofing material — asphalt shingles need at least 2/12, and standard installation requires 4/12 or greater.

Calculadoras Relacionadas